As a Hydraulic Concrete Block Machine Factory , Shengya introduces the precautions for the Hydraulic Gypsum Block Making Machine.
1. Before starting the Hydraulic Gypsum Block Making Machine every day, check whether the brick machine mold, the brick machine equipment fastening link is locked, the motor terminal block is loose, the oil pipe leaks oil, and the belt conveying and feeding direction are blocked. Normal to boot.
2. The hydraulic system cooler should be turned on before opening the Hydraulic Gypsum Block Making Machine in the summer. In winter, it should be preheated for half an hour before it can be put into operation. When the oil temperature exceeds 45 degrees, the cooler should be turned on before continuing to work. The rated oil temperature of the hydraulic device is 45-65 degrees. If it exceeds 65 degrees, it should be stopped and cooled before continuing to work.
3. After daily shutdown, the concrete and dirt on the machine table, the feeding car, the mold, the conveyor belt should be cleaned up to keep the production line clean and ensure that the brick machine equipment can operate normally the next day.
4. After the machine is shut down every day, check the key moving parts such as the upper and lower modules, bearings and screws of the cement brick machine, and add a proper amount of roller oil. If there is excess oil spill when refueling, it should be cleaned up in time to prevent the clay sand from damaging the machine.